Plain guides to DOT rules for truckers. Call when you are parked, never while driving.(305) 699-5857
Get a life quote

Pre-trip and DVIR

The CDL pre-trip inspection test

What the examiner scores, the order most candidates follow, and the air brake numbers you will be asked to say out loud.

A driver with a flashlight checks the engine under the tilted hood of her truck on a morning pre-trip inspection
Short answer

The CDL pre-trip is the vehicle inspection part of the skills test. You walk the vehicle, name and touch each part, and say what you are checking and why. The order most manuals teach is engine compartment, cab and engine start, external walkaround, coupling for Class A, then the trailer. The air brake check has three parts, and doing them wrong or out of order fails the whole inspection.1

Prices checked
No prices on this page
Rule checked
November 20, 2026, 49 CFR 393.51 and 393.95. Test content from the CDL manuals in the sources.
Applies to
Class A and Class B CDL applicants, and drivers who want to practice the same routine on the job.
On this page
  1. 01How is the CDL vehicle inspection test run?
  2. 02What order do most candidates follow?
  3. 03Where do you look on a tractor-trailer?
  4. 04What are the air brake numbers?
  5. 05How is Class A different from Class B?
  6. 06What gets candidates marked down?
  7. 07Questions people ask

How is the CDL vehicle inspection test run?

The manual covers the skills test in three sections, the vehicle inspection, basic vehicle control and the on-road drive, and the inspection comes first.1 It says you must show the vehicle is safe to drive, walk around it, name and point to or touch each item, and tell the examiner what you are checking and why.1 It is a spoken test. Looking at a part and saying nothing earns nothing.

You bring the vehicle. A vehicle with components marked or labeled cannot be used for the test.1 The examiner picks one of several equivalent versions and tells you just before you start, so you cannot plan to study only part of the truck. Plan to know all of it.

This page is the test script. For the daily check a working driver does, see the pre-trip inspection checklist. For the paper that follows the day, see the DVIR.

What order do most candidates follow?

The manual's own inspection guide has seven steps. The skills test section groups the same work into engine compartment, cab check, external inspection, coupling and trailer.1 Schools teach a front to back flow built on the same pieces, and the exact order can vary by state.5

  1. Overview. Look at the vehicle as you approach. Check for leaning, damage and fresh leaks underneath. Review the last inspection report.
  2. Engine compartment, engine off. Brakes set or wheels chocked. Oil, coolant, power steering fluid, belts, hoses and leaks.
  3. Start the engine and check the cab. Gauges, mirrors, windshield, wipers, horn, emergency equipment, lights and indicators, parking brake, brake checks and the safety belt.
  4. Walk around the outside. Steering, suspension, brakes, wheels, tires, fuel tank, drive shaft, exhaust and frame, on every axle.
  5. Coupling, Class A only. Air and electric lines, fifth wheel mounting, release lever, locking jaws and kingpin.
  6. Trailer. Front connections, landing gear, doors, frame and the same wheel and brake checks as the tractor.
  7. Final brake checks. Hydraulic pedal test or the full air brake check, then a service brake check at about 5 mph.
An owner-operator couple work through fuel receipts and truck paperwork at their kitchen table

Life insurance for drivers

Licensed agents compare several insurance companies and call you back with prices. You decide.

Get a life quoteOr call (305) 699-5857

Where do you look on a tractor-trailer?

The diagram numbers ten zones on a tractor-trailer combination. Phones hide the long labels, so the table under the figure lists every zone and what to name in it.

Side view of a tractor-trailer with ten numbered inspection zones from the engine compartment at the front to the rear doors and lights of the trailer. 1 2 3 4 5 6 7 8 9 10
Figure 1 ยท Ten inspection zones on a tractor-trailer, front to rear. The table below names what to say in each zone. Source 1.
ZoneAreaWhat you name and touch
1Engine compartmentLeaks, hoses, oil level, coolant level, power steering fluid, belts. Belts should show about 1/2 to 3/4 inch of play at the center, with no cracks or fraying.
2CabGauges, mirrors, windshield, wipers, horn, heater and defroster, dash indicators, emergency equipment, safety belt.
3Steer axleSteering box, hoses and linkage, front suspension, brake parts, wheels, rims, tires, hub seals.
4Tractor sideDoors and mirrors, fuel tank and cap, drive shaft, exhaust, diesel exhaust fluid level, frame.
5Drive axlesSprings or air bags, mounts, shocks, slack adjusters, pushrods, brake chambers, hoses, drums, lug nuts, tires.
6CouplingAir and electric lines, mounting bolts, release lever, locking jaws, skid plate, platform, kingpin, apron and gap.
7Trailer frontGlad hands, electrical plug, header board or front wall.
8Trailer sideLanding gear fully raised, frame, floor and cross members, doors, ties and straps, tandem release arm and pins.
9Trailer axlesSuspension, brakes, wheels, rims and tires, the same list as the drive axles.
10Trailer rearSplash guards, doors and latches, ties, cargo lift if equipped, lights, reflectors and reflective tape.

Checked November 20, 2026. Source 1, Sections 2.1 and 11. Zone numbering is ours. The manual groups the same parts by section, not by number.

What are the air brake numbers?

The air brake check is where most candidates lose points, because it is scored on both the numbers and the order. The model manual says failing to do all three parts correctly and in order is an automatic failure of the inspection.1

Air brake check, model manual wording

Start
Air built to governor cutout, 120 to 140 psi
Part 1
Engine off, key on, parking brake released, tractor protection valve released on a combination. Hold the foot brake one minute. Loss over 3 psi (single vehicle) or 4 psi (combination) is too much.
Part 2
Fan the pedal. The low air warning must activate before pressure falls below 55 psi, or the maker's level.
Part 3
Keep fanning. On a tractor-trailer the tractor protection valve and parking brake valve pop out between 20 and 45 psi. On other vehicles the parking brake valve pops out.
Checked
Nov 20, 2026

Section 5 of the same manual also describes a static leak check with the parking brake released and the engine off, with a loss of less than 2 psi in one minute for a single vehicle and less than 3 for a combination.1 Know your own state's wording, because examiners score against it.

How is Class A different from Class B?

The engine start and the in-cab check are in every version. What changes is the coupling and trailer work, and the extras on a bus.1

Part of the testClass AClass B
Versions the examiner can giveOne of four, all equivalentOne of three, all equivalent
Engine start and cab checkAlways includedAlways included
Coupling inspectionAlways includedNot part of the test
Trailer front, side and rearPart of the workNot listed
Rest of the vehicleWhole vehicle or a portionWhole vehicle or a portion
Special featuresNot listedYes, for example a school or transit bus

Checked November 20, 2026. Source 1, Sections 11.4 and 11.6. Class C is tested with Class B in the manual.

What gets candidates marked down?

  • A silent check. The manual wants the item named and the reason said aloud.
  • Half a brake check. On hydraulic brakes, both parts of the check are required. Pump the pedal three times and hold it five seconds with no movement, then listen for the reserve motor if equipped.1
  • Kicking tires. The manual says no credit for kicking or tapping. Use a gauge, check tread depth (4/32 inch on steer tires, 2/32 elsewhere) and look at valve stems and caps.1
  • Skipping an axle. Suspension, brakes and wheels must be checked on every axle, tractor and trailer.1
  • Missing emergency gear. You need a charged, mounted fire extinguisher and the warning devices the rule requires, which are three reflective triangles or at least six fusees.6

Questions people ask

Do I have to do the pre-trip from memory?

The test is spoken and you must name each item, so in practice yes. You are walking the examiner through the vehicle from your own knowledge of the steps.1

Is the Class B pre-trip shorter?

It skips the coupling inspection. You still start the engine, do the cab check and brake checks, and cover the vehicle or the portion the examiner names.1

Is the test pre-trip inspection the same as what drivers do daily?

The parts overlap, but the test asks for a full spoken walkthrough. A daily check is the driver's own look under the rule, covered on the checklist page.

Which psi number do I say for the low air warning?

Say the number in your state's manual. The newer model text prints 55 psi, and older printings and some school pages print 60.12

Back to the DOT Guidelines home page for every inspection and hours topic.

Sources (6)
  1. Kansas Commercial Driver's License Manual, AAMVA 05 model test version, June 2022, sections 2.1, 5 and 11, copy hosted by russiandmvtests.com, opened November 20, 2026. russiandmvtests.com
  2. Ohio Commercial Driver License Manual, 2005 CDL Testing System, AAMVA version July 2017, sections 5.3 and 11, hosted by Ohio State University, opened November 20, 2026. cfaessafety.osu.edu
  3. Legal Information Institute, Cornell Law School, Title 49 section 393.51 on warning signals and air pressure gauges, opened November 20, 2026. law.cornell.edu
  4. Progressive Truck Driving School, The Air Brakes Test Simplified, April 1, 2026, opened November 20, 2026. cdltruck.com
  5. Driving-Tests.org, CDL Pre-Trip Inspection Checklist, updated November 2026, opened November 20, 2026. driving-tests.org
  6. Legal Information Institute, Cornell Law School, Title 49 section 393.95 on emergency equipment, opened November 20, 2026. law.cornell.edu

Life insurance for drivers

You passed the pre-trip. Is your family covered?

Your numbers, your logbook and your fuel tax keep the truck legal. Life insurance keeps your family going if you are not there. A licensed agent compares life insurance from several insurance companies and calls you back with prices. You decide if and when to apply.

Get a life quoteOr call (305) 699-5857

DOT Guidelines is run by an independent, licensed insurance agency. We are not FMCSA, the U.S. DOT, CVSA, IFTA, a state agency, a filing or permit service or a motor carrier.

A burgundy semi truck with a white trailer drives a two-lane prairie highway at sunset
CallGet a life quote